LPCTools

LPCTools is an interface to NXP LPC Microcontrollers ISP (In-System Programming) serial interface.

It is split in two programs: lpcisp and lpcprog

lpcisp:

This tool gives access to each of the useful isp commands on LPC devices. It does not provide wrappers for flashing a device.

lpcprog:

This tool does not give access to each isp command, instead it provides wrappers for flashing a device.

Both programs were originally written by Nathael Pajani nathael.pajani@nathael.net because existing programs were published under non-free licenses, did not allow commercial use, or did not provide source code.

lpc_binary_check:

This third tool is an additional helper program created to change the user code and check that the CRP protection is not enabled in a binary image so that it can be uploaded to a target with different tools.

These programs are released under the terms of the GNU GPLv3 license as can be found on the GNU website : http://www.gnu.org/licenses/ or in the included LICENSE file.

Update RF-Sub 1GHz module

The new RF-Sub 1GHz module embeds a LPC1224 micro-controller with a new ID, so you need to add a new line in your lpctools_parts.def below the previous LPC1224 definition. The new line will look like this :

0x3642C02B, LPC1224FBD48/121,   0x00000000, 0x8000,  8,    0x04,    0x10000000, 0x1000, 0x800, 0x400,   1

If you installed lpctools globally in your system, look for the definitions file at /etc/lpctools_parts.def.