Late braking when reaching tip trigger in Mode2(Realistic Fill Type Mass Adjustment mod)

[Nebular64]

I noted the tractors with trailer are now delaying their braking when reaching the silo tip trigger. This causes the tractor to stop just past the trigger while trying to unload, so it just continues on its course back to the field. The "tip trigger reached" message now shows when the tractor is much closer to the trigger, so there doesn't appear to be much time for the tractor to brake.

I started to experience this when I updated from v.00121 to v.00126 (and now v.00127).

I thought maybe it could be one of the mods such as the Ground Response or Engine Braking, but the issue still exists after disabling such mods. I will attempt to revert back to v.00121 to confirm, but just wanted to see if its possible for me to edit the distance to brake before reaching tip trigger (if such a parameter).

[pops64]

How big is your tip trigger? If is of standard size you shouldn't be having this issue. A while ago I moved the tip point back to center of the trigger. Plus it still should be slowing down to 6 mph (Or your turn speed setting I believe. If it is higher than 6 I would recommend setting this back) at the same point before this change. Picture of your tip point please

[Nebular64]

@pops64 Thanks for the assist! The map is Grabbylatoosh`s edited version of Don Diego.
Below are pics of the silo trigger and CP speed settings. This pic is the approach point when the tractor hits the trigger, but hasn't started braking.

Here is the full pic of the trigger point

Current CP speeds set on this course

I've been using CP on this map without any problems and no updates have been applied to the map.
Let me know if you need anything else and I greatly appreciate the help.

[pops64]

Could you post a log with debug channel 1 and 21 active and take a picture when it says tip trigger is reached. It should say drive 836 if it is trying to set the correct speed when it reaches the tip trigger.

[Nebular64]

Log with debug channel 1 and 21 attached.
log.txt

Here is the drive(836) with a refspeed of 10

Tractor continues driving through tip point

Tractor stops right at the edge of the trigger with a drive(740). It use to stop with the trailer in the middle of the trigger, but now it's been a hit a miss with the tractor drifting past this point without finishing unloading

[pops64]

I would say try turning off all script based mods besides CP and what your map needs to run. Something is interfering with CP. Because CP is telling the tractor to slow down but something is overwriting CP.

[Nebular64]

That's why I thought it might have been a conflict with the Engine Brake mod, but I'll start deactivating other mods and continue testing.

[pops64]

Yea the refspeed = you see in channel 21 debugs is the speed in kph that CP is setting your cruise control to. But has you see in the FS GUI your cruise control is still set 22 mph or 43 kph.

[Nebular64]

Ok, I can't explain why it's causing a problem now, but my issue is with the Realistic Fill Type Mass Adjustment mod. I've been running this mod with CP for quite some time with no problems and now it looks like the culprit. I'll tweak the .lua file in this mod to try and resolve the problem.

I'm not sure if you have this mass adjustment mod for testing purposes, but I would be curious to see if you experience the issue since I can definitely recreate it when this mod is activated.

EDIT - Just FYI. I tested again with v.00129 with the same results. Works fine without the current mass adjustment.

[pops64]

I don't have it. That is interesting behavior indeed. We will have a look into and maybe figure out what is going on when we have time.