practable-portal

Practable Portal Installable Files for Raspberry Pi & Nano IoT

Nano IoT33 Installation

1. flash firmware mcu-firmware/practable-portal-iot-FW to Nano IoT33 Controller

SBC Installation

1. Starting with a fresh Raspberry Pi OS Installable
2. from CLI run git clone https://github.com/practable/practable-portal.git
3. Navigate into portal directory cd practable-portal
4. Run script ./install_portal.sh, Entering user password when requested
5. Run script setup_uart.sh, or if script fails, enable UART with raspi-config tool
6. reboot raspberry pi

Useage

• Stats screens should populate with values if valid connection between Raspberry Pi and MCU

• IP Address will only populate if raspberry pi has a valid network connection, showing connected status

• To remotely power cycle raspberry pi, run script ./practable-portal/safe_power_cycle.sh

  • system will do safe shut down, and MCU will cycle power to raspberry pi.
  • splash screen will show when raspberry pi is being re-powered.

• for remote shutdown send +3.3v signal to V_sbc-ext terminal from external source for >=3000 mS to trigger hard shutdown.

  • This will power cycle raspberry pi without initiating safe shutdown, and is intended for remote system recovery when the raspberry pi itself is unresponsive.